FAQ - Categories:

Wave Editor FAQ:

General

Composer FAQ:

Music Making

Products:

FlexiMusic Wave Editor

FlexiMusic Composer

FlexiMusic Kids Composer

FlexiMusic Generator

Give a gift

1. Run the FlexiMusic Wave Editor.

2. Use the File > New command to create a new file. For CD quality recording, use stereo, 16 bits and a sampling rate of 44100Hz.

3. Click on the screen once to select the position where you would insert the recorded wave sound.

4. Click the Record button (the red circle) on the tool button. This will open the Record window.

5. Choose Stereo Mix device or the equivalent, in the Recording Source drop down list. Click on "Volume" button to open the "Recording Source Volume Control" window, and then adjust the volume for Stereo Mix to the highest possible performance.

6. In Recording Source Volume Control window, Click "Show Others" button you might see other devices, such as CD-Player or Microphone, in the volume control panel, uncheck all non-essential devices, this cuts down background noise. (Remember to put it back "ON" after you finish recording).

7. Now start the playback of the WinAmp or the stream audio from Internet and click the "Start" button in Record Audio window of FlexiMusic Wave Editor. If necessary, Adjust the volume setting by seeing the levels of the volume going up an down on the vertical white  bar, of your voice being recorded.

8. You can pause the process of recording by clicking the "Pause" button any time you want and then resume it by clicking the "Continue" button.

9. When you want to stop recording, just click "Stop" button, Click "Done" button to finish recording and the destination sound file is there.

10. To save your recording, click the File menu and choose Save command.