| How to set my computer to
start recording at a certain time?
Yes, this can be done with
FlexiMusic Wave Editor. In the recording window, set the time and durations
in the Advanced Options.
1. Run the FlexiMusic Wave
Editor.
2. Use the File > New command
to create a new file. For CD quality recording, use stereo, 16 bits and a
sampling rate of 44100Hz.
3. Click on the screen once
to select the position where you would insert the recorded wave sound.
4. Click the Record button
(the red circle) on the tool button. This will open the Record window.
5. Before Recording, Make
sure to select the appropriate input device in which you are going to
record. Choose the device, in the Recording Source drop
down list. Click on "Volume" button to open the "Recording
Source Volume Control" window, and then adjust the volume for the highest
possible performance.
6. In the Advanced Options,
select (check mark) the options "Start recording at __" & "Stop
after recording for __".
7. To start recording
automatically, Set the time at
which the recording should start
in the "Start recording at" using the following format time:hour:minute:second
(hh:mm:ss) in 24 hour
clock format. (For example 9:30 AM will be written
as 09:30:00 and 7:40 PM will be written as 19:40:00.).
8. To stop
the recording automatically after a certain amount time
has passed set duration in "Stop after recording for" Enter the time in the
following format: hour:minute:second (hh:mm:ss) and
you may even use the format of mm:ss for just minutes:seconds.
(For example if you are recording for a half an hour will be written as
30:00)
9. Once
you have set the options correctly it will start the recording automatically
and stop the recording after certain durations. When you return your
recording is waiting for you.
10. Click "Done"
button to insert the recording into the file at the position you previously
selected.
11. Once
you have completed the recording, select the required portions only and use
the Trim command (Edit > Trim) to deletes any unused audio.
12. Listen
to the recording by pressing the Play button.
13. To
save your recording, click the File menu and choose Save command.
|
